Search for the length the job needs
Enter the material, the finished blank length and how many blanks. RemnantRack adds the processing allowance, kerf, trim and any setup buffer, and shows the complete calculation before it searches.

Which pieces are listed, and why
Results list only pieces of the exact material, in an accepted condition and long enough once measurement uncertainty is allowed for. Each one shows its rack and bin, spare length and why it was ranked where it is. When nothing fits, RemnantRack says so rather than suggesting a different material.
Reserve it for the job
Reserving a piece holds it for you and your job, for 30 minutes by default. Anyone else searching sees that it is taken. At the rack, the station checks out the reserved piece before it is moved or cut, and a different piece of the same material is refused, because it is not the one reserved.

Reports on reuse
Reports show the lengths reused, operations recorded, rack accuracy and the time spent registering and retrieving pieces. RemnantRack reports what happened; it does not estimate cash or carbon savings.
What RemnantRack does not do
- Cutting optimisation or nesting across your stock. It finds a suitable piece for one job at a time.
- Material substitution. Only the exact material, and any batch or condition the job requires, is offered.
- Saw control, purchasing or stock valuation.
Common questions
Does AI decide which piece we cut?
No. AI helps turn your plain English rules into precise conditions during setup. Your team tests and approves them. In the workshop, RemnantRack applies the rules as approved, without calling an AI model. A rule cannot certify a grade, measure a piece, approve a substitute material or authorise a cut.
What if no offcut is long enough?
The search says that no piece fits and shows the length it needed. RemnantRack never offers a different profile or grade instead, so the job is cut from new stock.
Offcuts get stood in a corner and the saw operator cuts into a new length anyway: how does RemnantRack get offcuts used first?
RemnantRack makes the right offcut quick to find: enter the material and the length the job needs, and it lists the pieces long enough once kerf, trim and measurement uncertainty are allowed for, with their rack and bin, in the order your policy sets. A piece a supervisor marks missing after a rack check stays out of search until it is found or written off. RemnantRack does not control the saw, so cutting into new stock stays a person’s decision.
Start free at one station and pay when you grow. While SmartFACT is in early access, we set your first workflow up with you.
