A label for each piece
Each piece label shows its reference, material, measured length with its uncertainty, condition, batch where known and its rack and bin, with a barcode. Labels print as 100 × 150 mm PDFs, downloaded or sent to the printer through SmartFACT PrintStation, and rack and bin cards identify each storage position.
Only the current label identifies a piece. A label from an earlier generation, such as one replaced when the piece moved, is refused at put-away instead of being guessed at.

Racks and bins set up for lengths
An administrator sets up each rack with an exact code and a name people recognise, then each bin with the material families it holds and the longest piece it accepts. Each bin gets its own card, downloaded as a PDF and placed at the bin.
At put-away, the bin card shows those limits for the operator to check. RemnantRack does not establish a rack's load or safety rating, and the bin's real physical suitability is checked separately.

Confirming the put-away
Printing a label does not make a piece available. The operator attaches it, scans the piece and the bin card, and confirms. A label that failed to print leaves the piece waiting for put-away, and reprinting the same label does not create another piece.

Cuts change the label
A cut retires the original piece and its label. The remainder gets a new piece reference and label, linked to the piece it came from. Scanning an old label shows that the piece has been used, rather than pointing at the remainder.

Rack checks
A rack check walks one section and scans every label. RemnantRack lists the pieces seen, the pieces missing, unexpected pieces and unreadable labels for review. Missing pieces are withheld from search until they are found or written off, and a piece is not deleted because it was not scanned.
A single piece can also be checked at its bin, for example after a reservation is released away from the rack. The operator scans the piece and the bin, compares the material, length and condition, and confirms before the piece is offered again.

What RemnantRack does not do
- Rack load or safety ratings. Bins record what they hold, not what a rack can bear.
- Sheets, panels or irregular shapes. Racks and bins hold straight lengths.
- Automatic location tracking. A piece's place is what people scan and confirm.
Common questions
What stops two people taking the same piece?
A reservation. Only one person can hold a piece at a time, and the reservation shows their name, the job and when it expires. Taking the piece from the rack needs a checkout at the station against that reservation, so the same offcut cannot go to two jobs.
Do labels stay on our material?
Test them before general use: attach test labels to real offcuts, handle them as the workshop would and scan them again. Where adhesive labels do not survive, use tags or sleeves. Label adhesion and scanning are checked on your material when the first rack is set up.
Start free at one station and pay when you grow. While SmartFACT is in early access, we set your first workflow up with you.
